[CLUE-Tech] replacing lilo

[thadeus]

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1


Hi guys,

I recently changed the landscape of my pc, wiping some partition to give
way for slackware 9.1. The former slack 9.0, which was replaced by a
fresh install of  slack 9.1, also holds the the lilo configuration i was
using then.

During the installation of Slack 9.1, i also did a simple lilo
configuration for the new landscape of my hard disk. However after
rebooting, its still the old lilo that was seen during booting? 

My question is how can i replace this lilo with the new configuration?
Below is the list of my partitions:


Disk /dev/hda: 30.7 GB, 30735581184 bytes
255 heads, 63 sectors/track, 3736 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

   Device Boot    Start       End    Blocks   Id  System
/dev/hda1             1       829   6658911    b  Win95 FAT32
/dev/hda2           830      2802  15848122+   f  Win95 Ext'd (LBA)
/dev/hda3          2803      3736   7502355   83  Linux  // redhat9.0
/dev/hda5           830      1276   3590496    b  Win95
FAT32/dev/hda6   *      1277      1342    530113+  83  Linux
/dev/hda7          1343      2132   6345643+  83  Linux  //slack9.1 /
/dev/hda8          2133      2193    489951   82  Linux swap
/dev/hda9          2194      2802   4891761   83  Linux // slack 9.1
/usr

TIA

thad

-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.2.1 (GNU/Linux)

iD8DBQE/iSidxguuR0e2MLYRAgTnAKCNc0Ny5yLTbThvp0B3/jF1WY4+pgCdE9HG
2EIN3EhXkOut2c28hokQ+nw=
=1ovD
-----END PGP SIGNATURE-----