[CLUE-Tech] WAP Power Supply Specs

[David L. Willson]

I have a universal power-supply with scaling voltage and reversible 
tipilarity.  You can borrow it for testing.

----- Original Message ----- 
From: "Jed S. Baer" <thag at frii.com>
To: <clue-tech at clue.denver.co.us>
Sent: Monday, November 22, 2004 5:04 PM
Subject: [CLUE-Tech] WAP Power Supply Specs


>I picked up a WAP at the TechAngle garage sale Saturday. It's an Addtron,
> based on the Eumitcon WL11000SA-N board. From what I can find, other WAPs
> also use this board, including:
>
>  US Robotics (USR 2450)
>  SMC EZconnect (2652W)
>  Something from Teletronics
>
> The problem I have is a power supply for it. Addtron apparently no longer
> exists. The User's Manual I can find on the web specifies a 9VDC,1A power
> supply, but not whether it's tip positive or negative. USR's product page
> also specifies the same, and also fails to mention tip polarity.
>
> Teletronics tech support says their product uses 5VDC, tip negative, but
> evidence is against that.
>
> Does anyone have a WAP using this board? If so, can you tell me what the
> specs are for the power supply?
>
> Even better, has anyone tossed a Eumitcon-based WAP, but kept the power
> supply? And if so, would you be willing to part with it?
>
> Thanks,
> jed
> -- 
> http://s88369986.onlinehome.us/freedomsight/
>
> ... it is poor civic hygiene to install technologies that could someday
> facilitate a police state. -- Bruce Schneier
> _______________________________________________
> CLUE-Tech mailing list
> Post messages to: CLUE-Tech at clue.denver.co.us
> Unsubscribe or manage your options: 
> http://clue.denver.co.us/mailman/listinfo/clue-tech
>